/*
*********************************************************************************************************
*                                       IAR Development Kits
*                                              on the
*
*                                    M451
*
* Filename      : uart_console.c
* Version       : V1.00
* Programmer(s) : Qian Xianghong
*********************************************************************************************************
*/

/*
*********************************************************************************************************
*                                             INCLUDE FILES
*********************************************************************************************************
*/

#include  "includes.h"

void Console_Init()
{
  LL_GPIO_InitTypeDef GPIO_InitStruct = {0};

  LL_AHB2_GRP1_EnableClock(LL_AHB2_GRP1_PERIPH_GPIOD);
  /**USART2 GPIO Configuration  
  PD5   ------> USART2_TX
  PD6   ------> USART2_RX 
  */
  GPIO_InitStruct.Pin = LL_GPIO_PIN_5|LL_GPIO_PIN_6;
  GPIO_InitStruct.Mode = LL_GPIO_MODE_ALTERNATE;
  GPIO_InitStruct.Speed = LL_GPIO_SPEED_FREQ_MEDIUM;
  GPIO_InitStruct.OutputType = LL_GPIO_OUTPUT_PUSHPULL;
  GPIO_InitStruct.Pull = LL_GPIO_PULL_NO;
  GPIO_InitStruct.Alternate = LL_GPIO_AF_7;
  LL_GPIO_Init(GPIOD, &GPIO_InitStruct);
}

void Console_Open()
{
  LL_USART_InitTypeDef USART_InitStruct = {0};

  /* Peripheral clock enable */
  LL_APB1_GRP1_EnableClock(LL_APB1_GRP1_PERIPH_USART2);
  
  /* USART2 interrupt Init */
  NVIC_SetPriority(USART2_IRQn, NVIC_EncodePriority(NVIC_GetPriorityGrouping(),5, 0));
  NVIC_EnableIRQ(USART2_IRQn);

  USART_InitStruct.BaudRate = 115200;
  USART_InitStruct.DataWidth = LL_USART_DATAWIDTH_8B;
  USART_InitStruct.StopBits = LL_USART_STOPBITS_1;
  USART_InitStruct.Parity = LL_USART_PARITY_NONE;
  USART_InitStruct.TransferDirection = LL_USART_DIRECTION_TX_RX;
  USART_InitStruct.HardwareFlowControl = LL_USART_HWCONTROL_NONE;
  USART_InitStruct.OverSampling = LL_USART_OVERSAMPLING_16;
  LL_USART_Init(USART2, &USART_InitStruct);
  LL_USART_ConfigAsyncMode(USART2);

  //SET_BIT(USART2->CR1, USART_CR1_PEIE | USART_CR1_RXNEIE);
  LL_USART_Enable(USART2);
}